This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
The IEC publishes a series of documents and rules governing the preparation of documents, drawings and the referencing of equipment. Depending on country...
When selecting a cable, the performance of the cable under fault conditions is an important consideration. It is important that calculations be carried...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
Most installations involve some form of lightning protection system which is connected to an earth electrode. The function of the earth electrode is to...
The term 'N+1' relates to redundancy and simply means that if you required 'N' items of equipment for something to work, you would have one additional...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
One of the comments on my Motor Starting Series was asking for something on duty cycles. Here it is. As a purchaser of a motor, you have responsibility...
When current flows within a wire, a magnetic field is created. The potion of this magnetic field perpendicular to the wire is called the magnetic flux...
Power cables can basically be classified into earthed and unearthed cables, where earthed and unearthed refer to the application for which the cable is...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.