Straight forward list of some common motor faults. If I have missed any other common faults, please take a bit of time to add them in as a comment below...
The calculation of current in a three phase system has been brought up on our site feedback and is a discussion I seem to get involved in every now and...
IEC 60287 "Calculation of the continuous current rating of cables (100% load factor)" is the International Standard which defines the procedures and equations...
When selecting a cable, the performance of the cable under fault conditions is an important consideration. It is important that calculations be carried...
For the past few years I have reading eBooks on my HTC touch phone. On and off I have debated buying an eReader and recently purchased a Sony PRS-300 ...
The IEC publishes a series of documents and rules governing the preparation of documents, drawings and the referencing of equipment. Depending on country...
The European Union is implementing a voluntary code of practice for participants with the aim of improving the overall efficiency of data centres. As part...
The IET site has a video of a visit showing of a high tech meeting room developed at Napier University in Edinburgh. It a good demonstration of innovative...
How often installations are inspected is up to the owner of the installation, provided such durations do not exceed any regulatory maximums in force. ...
The fundamental component of any analogue computer is the operational amplifier, or op amp. An operational amplifier (often called an op-amp,) is a high...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.