Power systems theory - generation, transmissions and distribution
While there are a vast array of cable insulation materials, these are often divided into two general types; Thermoplastic or Thermosetting. For example...
When looking at the design of a lighting scheme it is useful to have an understanding on the nature of light itself and some of the basic theory associated...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
Coils of wire on the rotor carry a d.c. current which generates a magnetic field. A stator magnetic field is created using either permanent magnets or...
Current transformers (CTs) are used to convert high level currents to a smaller more reasonable level for use as inputs to protection relays and metering...
We've been sending out Newsletters on a regular basis for a few weeks now. To do this we have been using Google's Feedburner service. While Feedburner...
One of the fundamental requirements of an alternating current distribution systems it to have the ability to change the magnitude of voltages. It is more...
Straight forward list of some common motor faults. If I have missed any other common faults, please take a bit of time to add them in as a comment below...
Low voltage (LV) switchrooms are common across all industries and one of the more common spatial requirements which need to be designed into a project...
The windings of many medium and small sized transformers are protected by restricted earth fault (REF) systems. The illustration shows the principal of...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.