Power systems theory - generation, transmissions and distribution
Our cable sizing tool is one of the more popular tools on the site. The tool enables cables to be sized in compliance with BS 7671 (the IEE Wiring Regulations...
Years ago I was told that you should always try to write the best report you can. Many years later I still think on this as one of the better pieces of...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
HTML supports a variety of entity symbols which can be entered using either numbers or an entity name. The number or name is preceded by the ‘&’ sign...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
The IEC publishes a series of documents and rules governing the preparation of documents, drawings and the referencing of equipment. Depending on country...
Reading is a bit of a hobby of mine and I"ve done a few off-topic posts in the past on this. Rather than continue doing the occasional post I thought ...
Often document control is dictated by project requirements, for example a particular organisation may have an existing numbering system. Existing company...
"I can live with doubt and uncertainty and not knowing. I think it is much more interesting to live not knowing than to have answers that might be wrong...
The widely used United Sates standard ANSI/IEEE C37.2 'Electrical Power System Device Function Numbers, Acronyms, and Contact Designations' deals with...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.