Fundamental electrical engineering concepts and theory
In electrical engineering, Network Theory is the study of how to solve circuit problems. By analyzing circuits, the engineer looks to determine the various...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
The calculation of current in a three phase system has been brought up on our site feedback and is a discussion I seem to get involved in every now and...
Problems on achieving maximum voltage drop within an installation come up often. Depending where you live, local regulations will have different limits...
For the past few years I have reading eBooks on my HTC touch phone. On and off I have debated buying an eReader and recently purchased a Sony PRS-300 ...
Often us engineers get so bogged down in equations, using software, producing drawings and writing specifications that this becomes the sole focus. ...
Some colleagues had an issue earlier in the week on sizing conduits to be cast in concrete for some power cables . It became clear that none of us had...
Fault calculations are one of the most common types of calculation carried out during the design and analysis of electrical systems. These calculations...
I think this post is going to be helpful to several of our readers. While the IEC low voltage circuit breaker Standard [IEC 60947-2, Low voltage switchgear...
Power cables can basically be classified into earthed and unearthed cables, where earthed and unearthed refer to the application for which the cable is...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.