If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...

Electrical engineering has a multitude of laws and theorems. It is fair to say the Ohm's Law is one of the more widely known; it not the most known. Developed...

When sizing cables, the heat generated  by losses within any sheath or armour need to be evaluated. When significant, it becomes a factor to be considered...

Within Europe the European Committee for Electrotechnical Standardization (CENELEC) has standardised the both the designation and colour of cables.   ...

Reading is a bit of a hobby of mine and I"ve done a few off-topic posts in the past on this. Rather than continue doing the occasional post I thought ...

The calculation of current in a three phase system has been brought up on our site feedback and is a discussion I seem to get involved in every now and...

I've recently come across this question a couple times browsing the internet. Decided to give a quick answer here. A rectifier transformer is a transformer...

The robot folding towels post below was interesting enough at the time to post a link.  Recently I’ve come across a couple of other interesting videos...

When selecting a cable, the performance of the cable under fault conditions is an important consideration. It is important that calculations be carried...

The International System of Units (abbreviated SI) is the world's most widely used system of units.  The system consists of a set of units and prefixes...