Electrical and related buildings technology
MIT OpenCourseWare, makes the materials used in teaching all MIT subjects available on the Web, free of charge, to any user in the world.
I was reminded of Occam's Razor while reading a book. It's quite a simple principal of logic which has stood the test of time and is accepted as central...
Low voltage (LV) switchrooms are common across all industries and one of the more common spatial requirements which need to be designed into a project...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
A UPS is an uninterruptible power supply. It is a device which maintains a continuous supply of electrical power, even in the event of failure of the...
A frequent problem in fault calculations is the obtaining of equipment parameters. While it is always preferable to use the actual parameters of the equipment...
Traditionally generation of electricity has involved rotating machines to produce alternating sinusoidal voltage and current (a.c. systems). With the development...
Electromechanical relays have been the traditional backbone of electrical protection systems. While over recent years these have been replaced by microprocessor...
Have an opinion or something to say, want to ask or answer questions, share your knowledge then use our site to do it . As a community of people interested...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.