Electrical and related buildings technology
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
Fault calculations are one of the most common types of calculation carried out during the design and analysis of electrical systems. These calculations...
Carrying out a protection system discrimination study is critical to ensure the correct functioning of the electrical system in the event of faults. ...
Low voltage (LV) switchrooms are common across all industries and one of the more common spatial requirements which need to be designed into a project...
I have been thinking recently that there appears to be less professional integrity around than when I first started my career in electrical engineering...
Battery powered cars are a hot topic and widely debated. The pros, cons, issues and time frames can be talked about endlessly. An article by the Telegraph...
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
If you at all familiar with programs like office and outlook, then adding and editing posts is pretty straightforward and intuitive. However, there are...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
Per unit fault calculations is a method whereby system impedances and quantities are normalised across different voltage levels to a common base. By removing...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.