myElectrical does not support or promote the use of copyrighted material without the copyright owner's consent. If you believe that material for which...
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
Current transformers (CTs) are used to convert high level currents to a smaller more reasonable level for use as inputs to protection relays and metering...
Electric motors are one of the most widely used items of electrical equipment. Improving motor efficiency benefits include, reduced power demand, lower...
Our IEE cable sizing was wrote a few years ago and had become rough around the edges. I thought it was time to give the tool a service. Unfortunately when...
A recurring theme on our forums is cable sizing. Now many installations are unique and require special consideration. However, a lot of the time things...
Capacitors are widely used in electrical engineering for functions such as energy storage, power factor correction, voltage compensation and many others...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
Over the past year or so I've been involved in on going discussions related to referring fault levels from the secondary of a transformer to the primary...
Straight forward list of some common motor faults. If I have missed any other common faults, please take a bit of time to add them in as a comment below...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.