Fundamental electrical engineering concepts and theory
The mobile phone was born in 1973. They were the size of a brick and weighed a couple of kg, making them difficult to fit into your pocket. At a few thousand...
Traditionally substations have used circuit breakers, current transformers (CT), voltage transformers (VT) and protection relays all wired together using...
The robot folding towels post below was interesting enough at the time to post a link. Recently I’ve come across a couple of other interesting videos...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
A frequent problem in fault calculations is the obtaining of equipment parameters. While it is always preferable to use the actual parameters of the equipment...
If you at all familiar with programs like office and outlook, then adding and editing posts is pretty straightforward and intuitive. However, there are...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
I've been considering a blog on the 110 or 230 Volt issue for a while. While browsing the Internet I came across a great summary by Borat over at engineering...
A quick post in connection with an email question: Live Tank - the circuit breaker the switching unit is located in an insulator bushing which is live...
I have been thinking recently that there appears to be less professional integrity around than when I first started my career in electrical engineering...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.