Fundamental electrical engineering concepts and theory
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
A single phase system is perhaps the most common type of system most people are familiar with. This is what people have in their homes and what appliances...
When sizing cables nearly, everyone uses some form of software. This ranges from homespun spreadsheets to complex network analyses software. Each has its...
These lifts were first built in 1884 by J. E. Hall and called a paternoster ("Our Father", the first two words of the Lord's Prayer in Latin) due to its...
Ever wondered what kind of power an aircraft uses when parked at the airport stand. Normally the aircraft generates it own power, but when parked with...
Resistors are electronic components that oppose the flow of current. Manufactured in various types and ranges they have a wide application to electronics...
myElectrical does not support or promote the use of copyrighted material without the copyright owner's consent. If you believe that material for which...
I was reminded of Occam's Razor while reading a book. It's quite a simple principal of logic which has stood the test of time and is accepted as central...
The widely used United Sates standard ANSI/IEEE C37.2 'Electrical Power System Device Function Numbers, Acronyms, and Contact Designations' deals with...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.