Fundamental electrical engineering concepts and theory
Cable insulation is used to provide electrical separation between conductors of a cable. During the historical development of cables, numerous types...
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
It starts with me reading one of the Horrible History books with my son (Groovy Greeks). Arrows were mentioned which lead to the discussion of the bodkin...
Per unit fault calculations is a method whereby system impedances and quantities are normalised across different voltage levels to a common base. By removing...
One of the comments on my Motor Starting Series was asking for something on duty cycles. Here it is. As a purchaser of a motor, you have responsibility...
Before the technical, some general information. E-ink display are found in a lot of e-readers, some mobile phones and similar devices and the intent is...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
The International System of Units (abbreviated SI) is the world's most widely used system of units. The system consists of a set of units and prefixes...
Sometimes it’s useful to be able to quickly lookup a piece of technical information. This note is a collection of information related to motors, and in...
This is the first of two posts on the resistance of conductors. In the next post I will look at the ac resistance, including skin effect and we deal with...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.