Fundamental electrical engineering concepts and theory
Our IEE cable sizing was wrote a few years ago and had become rough around the edges. I thought it was time to give the tool a service. Unfortunately when...
I've been considering a blog on the 110 or 230 Volt issue for a while. While browsing the Internet I came across a great summary by Borat over at engineering...
Estimating maximum demand is a topic frequently discussed. Working out how much power to allow for a building can be very subjective . Allowing too much...
Modelica is an open source (free) software language for modelling complex systems. Having never used it before, I thought I would download a development...
I was having a conversation the other day about voltage levels. While everyone was in agreement that low voltage was 1000 V and less, there was more confusion...
Our cable sizing tool is one of the more popular tools on the site. The tool enables cables to be sized in compliance with BS 7671 (the IEE Wiring Regulations...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
I've recently come across this question a couple times browsing the internet. Decided to give a quick answer here. A rectifier transformer is a transformer...
myElectrical does not support or promote the use of copyrighted material without the copyright owner's consent. If you believe that material for which...
Three phase systems are derived from three separate windings, either connected in delta or star (wye). Each winding can be treated separately, leading...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.