Fundamental electrical engineering concepts and theory
Cable insulation is used to provide electrical separation between conductors of a cable. During the historical development of cables, numerous types...
It wasn't so long ago I was telling someone that I don't use rules of thumb as most things are easily calculated anyhow. As it turns out I last week...
A UPS is an uninterruptible power supply. It is a device which maintains a continuous supply of electrical power, even in the event of failure of the...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
Various techniques exist to enable the correct selection of batteries for UPS applications. The procedure described below is one of the more common. ...
IEC 60228 is the International Electrotechnical Commission's international standard on conductors of insulated cables. Among other things, it defines a...
There are a lot of interesting two page type notes on various medium voltage topics – switchgear, circuit breakers, bus systems etc. It is on the Siemens...
If you at all familiar with programs like office and outlook, then adding and editing posts is pretty straightforward and intuitive. However, there are...
Anyone specifying or using electric motors should have a basic understanding how the insulation is related to temperature. Three classes of insulation...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.