Fundamental electrical engineering concepts and theory
I was reminded of Occam's Razor while reading a book. It's quite a simple principal of logic which has stood the test of time and is accepted as central...
A frequent problem in fault calculations is the obtaining of equipment parameters. While it is always preferable to use the actual parameters of the equipment...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
The standard aims to consolidate AC and traction voltages within the industry and defines the following bands: band 1 - A.C. systems 100 V to 1...
When current flows within a wire, a magnetic field is created. The potion of this magnetic field perpendicular to the wire is called the magnetic flux...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
myElectrical does not support or promote the use of copyrighted material without the copyright owner's consent. If you believe that material for which...
When selecting a cable, the performance of the cable under fault conditions is an important consideration. It is important that calculations be carried...
IEC 60947 is the circuit breaker standard and covers the marking of breakers in detail. Any manufacturer following this standard should comply with the...
Straight forward list of some common motor faults. If I have missed any other common faults, please take a bit of time to add them in as a comment below...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.