Power systems theory - generation, transmissions and distribution
This is the second post in a series of two on periodic electrical inspections. In the first post, I discussed how often inspections should be carried out...
The robot folding towels post below was interesting enough at the time to post a link. Recently I’ve come across a couple of other interesting videos...
I have been thinking recently that there appears to be less professional integrity around than when I first started my career in electrical engineering...
I think this post is going to be helpful to several of our readers. While the IEC low voltage circuit breaker Standard [IEC 60947-2, Low voltage switchgear...
The fundamental component of any analogue computer is the operational amplifier, or op amp. An operational amplifier (often called an op-amp,) is a high...
Electrical notes are a collaborative collection of electrical engineering information and educational material. Any registered user can add content. ...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
Estimating maximum demand is a topic frequently discussed. Working out how much power to allow for a building can be very subjective . Allowing too much...
These lifts were first built in 1884 by J. E. Hall and called a paternoster ("Our Father", the first two words of the Lord's Prayer in Latin) due to its...
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.