Power systems theory - generation, transmissions and distribution
Exposure to time varying magnetic fields, from power frequencies to the gigahertz range can have harmful consequences. A lot of research has been conducted...
A frequent problem in fault calculations is the obtaining of equipment parameters. While it is always preferable to use the actual parameters of the equipment...
The other day I came across an article in Technology Review on the development of a smart transformer. A professor at North Carolina State University is...
When selecting a cable, the performance of the cable under fault conditions is an important consideration. It is important that calculations be carried...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
Everything physical in electrical engineering from insulations to conductors revolves around materials. Here we are listing common materials along with...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
The standard aims to consolidate AC and traction voltages within the industry and defines the following bands: band 1 - A.C. systems 100 V to 1...
One of the comments on my Motor Starting Series was asking for something on duty cycles. Here it is. As a purchaser of a motor, you have responsibility...
Coils of wire on the rotor carry a d.c. current which generates a magnetic field. A stator magnetic field is created using either permanent magnets or...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.