Electrical and related buildings technology
Fault calculations are one of the most common types of calculation carried out during the design and analysis of electrical systems. These calculations...
Current transformers (CTs) are used to convert high level currents to a smaller more reasonable level for use as inputs to protection relays and metering...
IEC 60228 is the International Electrotechnical Commission's international standard on conductors of insulated cables. Among other things, it defines a...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
If you at all familiar with programs like office and outlook, then adding and editing posts is pretty straightforward and intuitive. However, there are...
Just added a page to the tools, which will allow you to calculate the synchronous speed, slip and rated torque for an induction motor. Not a particularly...
Coils of wire on the rotor carry a d.c. current which generates a magnetic field. A stator magnetic field is created using either permanent magnets or...
A recurring theme on our forums is cable sizing. Now many installations are unique and require special consideration. However, a lot of the time things...
Traditionally substations have used circuit breakers, current transformers (CT), voltage transformers (VT) and protection relays all wired together using...
The IEC publishes a series of documents and rules governing the preparation of documents, drawings and the referencing of equipment. Depending on country...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.