Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
I was reminded of Occam's Razor while reading a book. It's quite a simple principal of logic which has stood the test of time and is accepted as central...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
The calculation of current in a three phase system has been brought up on our site feedback and is a discussion I seem to get involved in every now and...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
Recently I have seen a few interesting articles on viable cold fusion; the combining of atoms at room like temperatures to create boundless energy. Now...
Famed English chemist and physicist Michael Faraday was born on September 22, 1791, in Newington Butts, a suburb of Surrey just south of the London Bridge...
Anyone specifying or using electric motors should have a basic understanding how the insulation is related to temperature. Three classes of insulation...
Coils of wire on the rotor carry a d.c. current which generates a magnetic field. A stator magnetic field is created using either permanent magnets or...
Modelica is an open source (free) software language for modelling complex systems. Having never used it before, I thought I would download a development...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.