I was digging in my bookshelf and came across the 80th Anniversary Association of Mine Resident Engineers, Papers and Discussions Commemorative Edition...
When selecting a generator, there are inherent limits on the active and reactive power which can be delivered. Generators are normally sized for a certain...
One of the fundamental requirements of an alternating current distribution systems it to have the ability to change the magnitude of voltages. It is more...
Electromechanical relays have been the traditional backbone of electrical protection systems. While over recent years these have been replaced by microprocessor...
Current transformers (CTs) are used to convert high level currents to a smaller more reasonable level for use as inputs to protection relays and metering...
I was reminded of Occam's Razor while reading a book. It's quite a simple principal of logic which has stood the test of time and is accepted as central...
Light Emitting Diodes (LED ) are increasing gaining favour in both the domestic and commercial sectors; due to their efficiency, sustainability and durability...
The 27 km, Euro 6 billion Collider lies on the border between France and Switzerland, took nearly 30 years to complete. Some of the lofty goals for the...
Low voltage (LV) switchrooms are common across all industries and one of the more common spatial requirements which need to be designed into a project...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.