Electromagnetic compatibility (EMC) is the study of coordinating electromagnetic fields give off equipment, with the withstand (compatibility) of other...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
When sizing cables nearly, everyone uses some form of software. This ranges from homespun spreadsheets to complex network analyses software. Each has its...
The European Union is implementing a voluntary code of practice for participants with the aim of improving the overall efficiency of data centres. As part...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
The calculation of current in a three phase system has been brought up on our site feedback and is a discussion I seem to get involved in every now and...
Current transformers (CTs) are used to convert high level currents to a smaller more reasonable level for use as inputs to protection relays and metering...
Alternating current (a.c.) is the backbone of modern electrical power distribution. In this article I’ll be pulling some of the more important concepts...
Battery powered cars are a hot topic and widely debated. The pros, cons, issues and time frames can be talked about endlessly. An article by the Telegraph...
Multimeters are undoubtedly the most common item of electrical test equipment in use. Often it is the first piece of equipment people will turn to when...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.