Fundamental electrical engineering concepts and theory
Fault calculations are one of the most common types of calculation carried out during the design and analysis of electrical systems. These calculations...
Traditionally substations have used circuit breakers, current transformers (CT), voltage transformers (VT) and protection relays all wired together using...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
Photovoltaic (PV) cells (sometimes called solar cells) convert solar energy into electrical energy. Every year more and more PV systems are installed...
GE have put together a time-lapse video shown flight take-off and landings at some airports. An interesting view:
Electrical engineering has a multitude of laws and theorems. It is fair to say the Ohm's Law is one of the more widely known; it not the most known. Developed...
One of the comments on my Motor Starting Series was asking for something on duty cycles. Here it is. As a purchaser of a motor, you have responsibility...
Most installations involve some form of lightning protection system which is connected to an earth electrode. The function of the earth electrode is to...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
Our cable sizing tool is one of the more popular tools on the site. The tool enables cables to be sized in compliance with BS 7671 (the IEE Wiring Regulations...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.