Fundamental electrical engineering concepts and theory
Over recent years the Lithium Ion battery has become popular in applications requiring high power densities with small weight and footprint. Today Lithium...
I have been thinking recently that there appears to be less professional integrity around than when I first started my career in electrical engineering...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
Low voltage (LV) switchrooms are common across all industries and one of the more common spatial requirements which need to be designed into a project...
Electrical engineering is a field that covers a wide variety of sub-fields, including electricity and electronics. It is a field that goes back to the...
I've been considering a blog on the 110 or 230 Volt issue for a while. While browsing the Internet I came across a great summary by Borat over at engineering...
The International System of Units (abbreviated SI) is the world's most widely used system of units. The system consists of a set of units and prefixes...
Some colleagues had an issue earlier in the week on sizing conduits to be cast in concrete for some power cables . It became clear that none of us had...
IEC 60287 "Calculation of the continuous current rating of cables (100% load factor)" is the International Standard which defines the procedures and equations...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.