Fundamental electrical engineering concepts and theory
Before the technical, some general information. E-ink display are found in a lot of e-readers, some mobile phones and similar devices and the intent is...
The calculation of current in a three phase system has been brought up on our site feedback and is a discussion I seem to get involved in every now and...
This morning I was explaining how differential protection works to a junior engineer. To give him something to read I opened up the NPAG (Network Protection...
GE have put together a time-lapse video shown flight take-off and landings at some airports. An interesting view:
The IET site has a video of a visit showing of a high tech meeting room developed at Napier University in Edinburgh. It a good demonstration of innovative...
Carrying out a protection system discrimination study is critical to ensure the correct functioning of the electrical system in the event of faults. ...
When sizing cables nearly, everyone uses some form of software. This ranges from homespun spreadsheets to complex network analyses software. Each has its...
Fault calculations are one of the most common types of calculation carried out during the design and analysis of electrical systems. These calculations...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
In 2011, with the introduction of it’s Panda search ranking algorithms, Google introduced tools for determining the original author of posts. The intention...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.