Fundamental electrical engineering concepts and theory
A load flow study is the analysis of an electrical network carried out by an electrical engineer. The purpose is to understand how power flows around...
Various techniques exist to enable the correct selection of batteries for UPS applications. The procedure described below is one of the more common. ...
MIT OpenCourseWare, makes the materials used in teaching all MIT subjects available on the Web, free of charge, to any user in the world.
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
The calculation of current in a three phase system has been brought up on our site feedback and is a discussion I seem to get involved in every now and...
I was reminded of Occam's Razor while reading a book. It's quite a simple principal of logic which has stood the test of time and is accepted as central...
If you at all familiar with programs like office and outlook, then adding and editing posts is pretty straightforward and intuitive. However, there are...
In an earlier note on the site [Photovoltaic (PV) - Electrical Calculations], the theory of solar (PV) cell calculations was introduced. In particular...
Electromechanical relays have been the traditional backbone of electrical protection systems. While over recent years these have been replaced by microprocessor...
I've recently come across this question a couple times browsing the internet. Decided to give a quick answer here. A rectifier transformer is a transformer...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.