Fundamental electrical engineering concepts and theory
When sizing cables nearly, everyone uses some form of software. This ranges from homespun spreadsheets to complex network analyses software. Each has its...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
Before the technical, some general information. E-ink display are found in a lot of e-readers, some mobile phones and similar devices and the intent is...
How often installations are inspected is up to the owner of the installation, provided such durations do not exceed any regulatory maximums in force. ...
Lamps are the essential part of any luminaire. These are the light generating components. Since the advent of electrical lighting in the middle of the...
Electromechanical relays have been the traditional backbone of electrical protection systems. While over recent years these have been replaced by microprocessor...
Most installations involve some form of lightning protection system which is connected to an earth electrode. The function of the earth electrode is to...
IEC 61439 'Low-voltage switchgear and controlgear assemblies', specifies standard arrangements of switchboard (call forms of internal separation). The...
Tapping your forearm or hand with a finger could soon be the way you interact with gadgets. A new technology created by Microsoft and Carnegie Mellon ...
When selecting a generator, there are inherent limits on the active and reactive power which can be delivered. Generators are normally sized for a certain...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.