Fundamental electrical engineering concepts and theory
Our IEE cable sizing was wrote a few years ago and had become rough around the edges. I thought it was time to give the tool a service. Unfortunately when...
Three phase systems are derived from three separate windings, either connected in delta or star (wye). Each winding can be treated separately, leading...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
A single phase system is perhaps the most common type of system most people are familiar with. This is what people have in their homes and what appliances...
Installation of a UPS can help in reducing problems due to issues with the power supply. A lot of people relate this to nine key issues. Depending on...
Traditionally generation of electricity has involved rotating machines to produce alternating sinusoidal voltage and current (a.c. systems). With the development...
These lifts were first built in 1884 by J. E. Hall and called a paternoster ("Our Father", the first two words of the Lord's Prayer in Latin) due to its...
HTML supports a variety of entity symbols which can be entered using either numbers or an entity name. The number or name is preceded by the ‘&’ sign...
Insulation on a motor prevents interconnection of windings and the winding to earth. When looking at motors, it is important to understand how the insulation...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.