Power systems theory - generation, transmissions and distribution
IEC 61439 'Low-voltage switchgear and controlgear assemblies', specifies standard arrangements of switchboard (call forms of internal separation). The...
Lamps are the essential part of any luminaire. These are the light generating components. Since the advent of electrical lighting in the middle of the...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
The fundamental component of any analogue computer is the operational amplifier, or op amp. An operational amplifier (often called an op-amp,) is a high...
Power cables can basically be classified into earthed and unearthed cables, where earthed and unearthed refer to the application for which the cable is...
Per unit fault calculations is a method whereby system impedances and quantities are normalised across different voltage levels to a common base. By removing...
Capacitors have numerous applications in electrical and electronic applications. This note examines the use of capacitors to store electrical energy....
Traditionally substations have used circuit breakers, current transformers (CT), voltage transformers (VT) and protection relays all wired together using...
Reading is a bit of a hobby of mine and I"ve done a few off-topic posts in the past on this. Rather than continue doing the occasional post I thought ...
Before the technical, some general information. E-ink display are found in a lot of e-readers, some mobile phones and similar devices and the intent is...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.