Power systems theory - generation, transmissions and distribution
Often document control is dictated by project requirements, for example a particular organisation may have an existing numbering system. Existing company...
Before the technical, some general information. E-ink display are found in a lot of e-readers, some mobile phones and similar devices and the intent is...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
The IET site has a video of a visit showing of a high tech meeting room developed at Napier University in Edinburgh. It a good demonstration of innovative...
IEC 62305 'Protection against lightning' requires a risk assessment be carried out to determine the characteristics of any lightning protection system...
Various techniques exist to enable the correct selection of batteries for UPS applications. The procedure described below is one of the more common. ...
The robot folding towels post below was interesting enough at the time to post a link. Recently I’ve come across a couple of other interesting videos...
Ever wondered what kind of power an aircraft uses when parked at the airport stand. Normally the aircraft generates it own power, but when parked with...
Electrical engineering has a multitude of laws and theorems. It is fair to say the Ohm's Law is one of the more widely known; it not the most known. Developed...
The windings of many medium and small sized transformers are protected by restricted earth fault (REF) systems. The illustration shows the principal of...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.