Power systems theory - generation, transmissions and distribution
Dielectrics (insulating materials for example) when subjected to a varying electric field, will have some energy loss. The varying electric field causes...
Installation of a UPS can help in reducing problems due to issues with the power supply. A lot of people relate this to nine key issues. Depending on...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
Estimating maximum demand is a topic frequently discussed. Working out how much power to allow for a building can be very subjective . Allowing too much...
The fundamental component of any analogue computer is the operational amplifier, or op amp. An operational amplifier (often called an op-amp,) is a high...
Cable insulation is used to provide electrical separation between conductors of a cable. During the historical development of cables, numerous types...
When selecting a cable, the performance of the cable under fault conditions is an important consideration. It is important that calculations be carried...
This post is quick introduction and overview to different railway electrification voltages used in answer to a question sent in via email. While there...
The robot folding towels post below was interesting enough at the time to post a link. Recently I’ve come across a couple of other interesting videos...
A load flow study is the analysis of an electrical network carried out by an electrical engineer. The purpose is to understand how power flows around...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.