Power systems theory - generation, transmissions and distribution
One of the requirements to ensuring that everything works is to have equipment selected, manufactured and verified [tested] to IEC standards. Not all equipment...
Often us engineers get so bogged down in equations, using software, producing drawings and writing specifications that this becomes the sole focus. ...
I've been considering a blog on the 110 or 230 Volt issue for a while. While browsing the Internet I came across a great summary by Borat over at engineering...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
Delum, who had watched all in silence, his face empty of expression, now spoke in turn. ' "Lead us, Warleader, into glory."' Reading is something I do...
Earthing of electrical systems is essential for the correct functioning and the protecting of life and equipment in the event of faults. The earth electrode...
The International System of Units (abbreviated SI) is the world's most widely used system of units. The system consists of a set of units and prefixes...
Estimating maximum demand is a topic frequently discussed. Working out how much power to allow for a building can be very subjective . Allowing too much...
The fundamental component of any analogue computer is the operational amplifier, or op amp. An operational amplifier (often called an op-amp,) is a high...
The other day I was talking to a colleague who is a building services consultant. Despite regularly specifying dry-type/cast resin transformers he was...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.