Power systems theory - generation, transmissions and distribution
Coils of wire on the rotor carry a d.c. current which generates a magnetic field. A stator magnetic field is created using either permanent magnets or...
A lot of our members work in countries where PPE (personal protective equipment) is regulated or they work for companies/organizations which take employee...
In a previous article I looked at the dc resistance of conductors and in this article we turn our attention to ac resistance. If you have not read the...
Before the technical, some general information. E-ink display are found in a lot of e-readers, some mobile phones and similar devices and the intent is...
"I can live with doubt and uncertainty and not knowing. I think it is much more interesting to live not knowing than to have answers that might be wrong...
Electromechanical relays have been the traditional backbone of electrical protection systems. While over recent years these have been replaced by microprocessor...
Photovoltaic (PV) systems are typically more efficient when connected in parallel with a main power gird. During periods when the PV system generates energy...
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
Problems on achieving maximum voltage drop within an installation come up often. Depending where you live, local regulations will have different limits...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.