Power systems theory - generation, transmissions and distribution
Before the technical, some general information. E-ink display are found in a lot of e-readers, some mobile phones and similar devices and the intent is...
Reading is a bit of a hobby of mine and I"ve done a few off-topic posts in the past on this. Rather than continue doing the occasional post I thought ...
The windings of many medium and small sized transformers are protected by restricted earth fault (REF) systems. The illustration shows the principal of...
When selecting a cable, the performance of the cable under fault conditions is an important consideration. It is important that calculations be carried...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
I was reminded of Occam's Razor while reading a book. It's quite a simple principal of logic which has stood the test of time and is accepted as central...
Problems on achieving maximum voltage drop within an installation come up often. Depending where you live, local regulations will have different limits...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
The new standard IEC 61439 replaces the old 60439. Compared to the old standard, the new 61439 is a more clearly defined and takes into account the assembly...
A lot of our members work in countries where PPE (personal protective equipment) is regulated or they work for companies/organizations which take employee...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.