Electrical equipment - design, use and implementation
Electrical engineering has a multitude of laws and theorems. It is fair to say the Ohm's Law is one of the more widely known; it not the most known. Developed...
ABB has produced a range of technical guides that offer concise explanations of the major technologies and technical issues in low voltage AC drives. ...
In a previous article I looked at the dc resistance of conductors and in this article we turn our attention to ac resistance. If you have not read the...
It's been a busy few months on different projects or busy couple of decades depending on how I look at it. I can say that on the odd (frequent) occasion...
Power factor is the ratio between the real power (P in kW) and apparent power (S in kVA) drawn by an electrical load. The reactive power (Q in kVAr)...
I received this question by email a few weeks. First thoughts was that it is a product of the mathematics of rotating a straight conductor in a magnetic...
Per unit fault calculations is a method whereby system impedances and quantities are normalised across different voltage levels to a common base. By removing...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
The windings of many medium and small sized transformers are protected by restricted earth fault (REF) systems. The illustration shows the principal of...
A lot of our members work in countries where PPE (personal protective equipment) is regulated or they work for companies/organizations which take employee...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.