The fundamental component of any analogue computer is the operational amplifier, or op amp. An operational amplifier (often called an op-amp,) is a high...
The widely used United Sates standard ANSI/IEEE C37.2 'Electrical Power System Device Function Numbers, Acronyms, and Contact Designations' deals with...
Installation of a UPS can help in reducing problems due to issues with the power supply. A lot of people relate this to nine key issues. Depending on...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
Electrical notes are a collaborative collection of electrical engineering information and educational material. Any registered user can add content. ...
It's been a busy few months on different projects or busy couple of decades depending on how I look at it. I can say that on the odd (frequent) occasion...
Collection of links to various places with useful motor information. I’ll try and return to the page every now and again to update it with any motor notes...
Fault calculations are one of the most common types of calculation carried out during the design and analysis of electrical systems. These calculations...
Circuit breakers are switching devices whose primary function is to isolate parts of an electrical distribution system in the even of abnormal conditions...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.