Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
Delum, who had watched all in silence, his face empty of expression, now spoke in turn. ' "Lead us, Warleader, into glory."' Reading is something I do...
The widely used United Sates standard ANSI/IEEE C37.2 'Electrical Power System Device Function Numbers, Acronyms, and Contact Designations' deals with...
The calculation of current in a three phase system has been brought up on our site feedback and is a discussion I seem to get involved in every now and...
The International System of Units (abbreviated SI) is the world's most widely used system of units. The system consists of a set of units and prefixes...
Per unit fault calculations is a method whereby system impedances and quantities are normalised across different voltage levels to a common base. By removing...
Three phase systems are derived from three separate windings, either connected in delta or star (wye). Each winding can be treated separately, leading...
These lifts were first built in 1884 by J. E. Hall and called a paternoster ("Our Father", the first two words of the Lord's Prayer in Latin) due to its...
Electromechanical relays have been the traditional backbone of electrical protection systems. While over recent years these have been replaced by microprocessor...
Laplace transforms and their inverse are a mathematical technique which allows us to solve differential equations, by primarily using algebraic methods...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.