Fundamental electrical engineering concepts and theory
Alternating current (a.c.) is the backbone of modern electrical power distribution. In this article I’ll be pulling some of the more important concepts...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
I think this post is going to be helpful to several of our readers. While the IEC low voltage circuit breaker Standard [IEC 60947-2, Low voltage switchgear...
This is the first of two posts on the resistance of conductors. In the next post I will look at the ac resistance, including skin effect and we deal with...
Traditionally substations have used circuit breakers, current transformers (CT), voltage transformers (VT) and protection relays all wired together using...
One of the comments on my Motor Starting Series was asking for something on duty cycles. Here it is. As a purchaser of a motor, you have responsibility...
This post is quick introduction and overview to different railway electrification voltages used in answer to a question sent in via email. While there...
Installation of a UPS can help in reducing problems due to issues with the power supply. A lot of people relate this to nine key issues. Depending on...
IEC 60287 "Calculation of the continuous current rating of cables (100% load factor)" is the International Standard which defines the procedures and equations...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.