Fundamental electrical engineering concepts and theory
One of the requirements to ensuring that everything works is to have equipment selected, manufactured and verified [tested] to IEC standards. Not all equipment...
‘Kept looking at a card, y’see? Kept looking at it. Welcome back Bottle. Gods below welcome home. The Crippled God A Tale of the Malazan Book of the...
Our question and answer system while letting you do exactly what it says, is much more. It is a dynamic user driven system, where our users not only ask...
Fault calculations are one of the most common types of calculation carried out during the design and analysis of electrical systems. These calculations...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
For the past few years I have reading eBooks on my HTC touch phone. On and off I have debated buying an eReader and recently purchased a Sony PRS-300 ...
Per unit fault calculations is a method whereby system impedances and quantities are normalised across different voltage levels to a common base. By removing...
Many questions sent in to the site are in connection with motor starting and in particular star-delta. For all but the simplest application, there is...
Traditionally substations have used circuit breakers, current transformers (CT), voltage transformers (VT) and protection relays all wired together using...
Various techniques exist to enable the correct selection of batteries for UPS applications. The procedure described below is one of the more common. ...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.