Fundamental electrical engineering concepts and theory
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
Problems on achieving maximum voltage drop within an installation come up often. Depending where you live, local regulations will have different limits...
The widely used United Sates standard ANSI/IEEE C37.2 'Electrical Power System Device Function Numbers, Acronyms, and Contact Designations' deals with...
The calculation of current in a three phase system has been brought up on our site feedback and is a discussion I seem to get involved in every now and...
One of the requirements to ensuring that everything works is to have equipment selected, manufactured and verified [tested] to IEC standards. Not all equipment...
We have a sister note to this (Robots - Interesting Video), in which I have posted some videos of interesting robots developed by commercial corporations...
IEC 60947 is the circuit breaker standard and covers the marking of breakers in detail. Any manufacturer following this standard should comply with the...
Just added a page to the tools, which will allow you to calculate the synchronous speed, slip and rated torque for an induction motor. Not a particularly...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.