Fundamental electrical engineering concepts and theory
This is the second post in a series of two on periodic electrical inspections. In the first post, I discussed how often inspections should be carried out...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
Using software in our work is essential for most of us and we are becoming even more dependant on it's use. While software is a great asset, many times...
The correct sizing of current transformers is required to ensure satisfactory operation of measuring instruments and protection relays. Several methods...
The windings of many medium and small sized transformers are protected by restricted earth fault (REF) systems. The illustration shows the principal of...
Lamps are the essential part of any luminaire. These are the light generating components. Since the advent of electrical lighting in the middle of the...
Power factor is the ratio between the real power (P in kW) and apparent power (S in kVA) drawn by an electrical load. The reactive power (Q in kVAr)...
Battery powered cars are a hot topic and widely debated. The pros, cons, issues and time frames can be talked about endlessly. An article by the Telegraph...
Our IEE cable sizing was wrote a few years ago and had become rough around the edges. I thought it was time to give the tool a service. Unfortunately when...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.