Fundamental electrical engineering concepts and theory
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
If you are wondering what happened to our cable notes, the short answer is that we have moved them to myCableEngineering.com. The "Knowledge Base" at...
The calculation of current in a three phase system has been brought up on our site feedback and is a discussion I seem to get involved in every now and...
Over the past year or so I've been involved in on going discussions related to referring fault levels from the secondary of a transformer to the primary...
IEEE TV has a part series of videos on wind power and it's implication. For a really good overview to the technologies and issues around wind power, these...
I've recently come across this question a couple times browsing the internet. Decided to give a quick answer here. A rectifier transformer is a transformer...
Per unit fault calculations is a method whereby system impedances and quantities are normalised across different voltage levels to a common base. By removing...
When selecting a cable, the performance of the cable under fault conditions is an important consideration. It is important that calculations be carried...
The new standard IEC 61439 replaces the old 60439. Compared to the old standard, the new 61439 is a more clearly defined and takes into account the assembly...
When sizing cables, the heat generated by losses within any sheath or armour need to be evaluated. When significant, it becomes a factor to be considered...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.