Fundamental electrical engineering concepts and theory
A recurring theme on our forums is cable sizing. Now many installations are unique and require special consideration. However, a lot of the time things...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
When selecting a generator, there are inherent limits on the active and reactive power which can be delivered. Generators are normally sized for a certain...
Straight forward list of some common motor faults. If I have missed any other common faults, please take a bit of time to add them in as a comment below...
myElectrical does not support or promote the use of copyrighted material without the copyright owner's consent. If you believe that material for which...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
Per unit fault calculations is a method whereby system impedances and quantities are normalised across different voltage levels to a common base. By removing...
We have a sister note to this (Robots - Interesting Video), in which I have posted some videos of interesting robots developed by commercial corporations...
I received this question by email a few weeks. First thoughts was that it is a product of the mathematics of rotating a straight conductor in a magnetic...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.