Fundamental electrical engineering concepts and theory
Collection of links to various places with useful motor information. I’ll try and return to the page every now and again to update it with any motor notes...
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
The widely used United Sates standard ANSI/IEEE C37.2 'Electrical Power System Device Function Numbers, Acronyms, and Contact Designations' deals with...
Famed English chemist and physicist Michael Faraday was born on September 22, 1791, in Newington Butts, a suburb of Surrey just south of the London Bridge...
Over the past year or so I've been involved in on going discussions related to referring fault levels from the secondary of a transformer to the primary...
Coils of wire on the rotor carry a d.c. current which generates a magnetic field. A stator magnetic field is created using either permanent magnets or...
Within Europe the European Committee for Electrotechnical Standardization (CENELEC) has standardised the both the designation and colour of cables. ...
This is the second post in a series of two on periodic electrical inspections. In the first post, I discussed how often inspections should be carried out...
Our question and answer system while letting you do exactly what it says, is much more. It is a dynamic user driven system, where our users not only ask...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.