Fundamental electrical engineering concepts and theory
The correct sizing of current transformers is required to ensure satisfactory operation of measuring instruments and protection relays. Several methods...
A quick post in connection with an email question: Live Tank - the circuit breaker the switching unit is located in an insulator bushing which is live...
I think this post is going to be helpful to several of our readers. While the IEC low voltage circuit breaker Standard [IEC 60947-2, Low voltage switchgear...
Power cables can basically be classified into earthed and unearthed cables, where earthed and unearthed refer to the application for which the cable is...
This is the first of two posts on the resistance of conductors. In the next post I will look at the ac resistance, including skin effect and we deal with...
Electrical engineering has a multitude of laws and theorems. It is fair to say the Ohm's Law is one of the more widely known; it not the most known. Developed...
The IET site has a video of a visit showing of a high tech meeting room developed at Napier University in Edinburgh. It a good demonstration of innovative...
Fault calculations are one of the most common types of calculation carried out during the design and analysis of electrical systems. These calculations...
A recurring theme on our forums is cable sizing. Now many installations are unique and require special consideration. However, a lot of the time things...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.