Fundamental electrical engineering concepts and theory
Often document control is dictated by project requirements, for example a particular organisation may have an existing numbering system. Existing company...
This post is quick introduction and overview to different railway electrification voltages used in answer to a question sent in via email. While there...
Electromagnetic compatibility (EMC) is the study of coordinating electromagnetic fields give off equipment, with the withstand (compatibility) of other...
IEC 61439 'Low-voltage switchgear and controlgear assemblies', specifies standard arrangements of switchboard (call forms of internal separation). The...
A lot of our members work in countries where PPE (personal protective equipment) is regulated or they work for companies/organizations which take employee...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
The fundamental component of any analogue computer is the operational amplifier, or op amp. An operational amplifier (often called an op-amp,) is a high...
Control theory looks at how systems work and are controlled from a mathematical view. This note gives a brief introduction to some of the concepts – more...
I was reminded of Occam's Razor while reading a book. It's quite a simple principal of logic which has stood the test of time and is accepted as central...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.