Fundamental electrical engineering concepts and theory
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
I have been thinking recently that there appears to be less professional integrity around than when I first started my career in electrical engineering...
The following tables provide quick order of magnitude fault levels for a a range of typical low voltage situations.
Insulation on a motor prevents interconnection of windings and the winding to earth. When looking at motors, it is important to understand how the insulation...
The other day I was talking to a colleague who is a building services consultant. Despite regularly specifying dry-type/cast resin transformers he was...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
Famed English chemist and physicist Michael Faraday was born on September 22, 1791, in Newington Butts, a suburb of Surrey just south of the London Bridge...
Power factor is the ratio between the real power (P in kW) and apparent power (S in kVA) drawn by an electrical load. The reactive power (Q in kVAr)...
A single phase system is perhaps the most common type of system most people are familiar with. This is what people have in their homes and what appliances...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.