Power systems theory - generation, transmissions and distribution
In a previous article I looked at the dc resistance of conductors and in this article we turn our attention to ac resistance. If you have not read the...
Power factor is the ratio between the real power (P in kW) and apparent power (S in kVA) drawn by an electrical load. The reactive power (Q in kVAr)...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
The other day I came across an article in Technology Review on the development of a smart transformer. A professor at North Carolina State University is...
Famed English chemist and physicist Michael Faraday was born on September 22, 1791, in Newington Butts, a suburb of Surrey just south of the London Bridge...
Over the past year or so I've been involved in on going discussions related to referring fault levels from the secondary of a transformer to the primary...
Cable insulation is used to provide electrical separation between conductors of a cable. During the historical development of cables, numerous types...
Straight forward list of some common motor faults. If I have missed any other common faults, please take a bit of time to add them in as a comment below...
The European Union is implementing a voluntary code of practice for participants with the aim of improving the overall efficiency of data centres. As part...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.