Power systems theory - generation, transmissions and distribution
Power cables can basically be classified into earthed and unearthed cables, where earthed and unearthed refer to the application for which the cable is...
Working in the vicinity of electrical equipment poses an hazard. In addition to electric shock hazard, fault currents passing through air causes Arc Flash...
How often installations are inspected is up to the owner of the installation, provided such durations do not exceed any regulatory maximums in force. ...
From the earliest times, humans have found ways to create light. Pre-historic peoples used natural materials (moss, grass, etc.) soaked in animal fat and...
Resistors are electronic components that oppose the flow of current. Manufactured in various types and ranges they have a wide application to electronics...
Alternating current (a.c.) is the backbone of modern electrical power distribution. In this article I’ll be pulling some of the more important concepts...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
A frequent problem in fault calculations is the obtaining of equipment parameters. While it is always preferable to use the actual parameters of the equipment...
I was reminded of Occam's Razor while reading a book. It's quite a simple principal of logic which has stood the test of time and is accepted as central...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.