Electrical and related buildings technology
Within Europe the European Committee for Electrotechnical Standardization (CENELEC) has standardised the both the designation and colour of cables. ...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
Our cable sizing tool is one of the more popular tools on the site. The tool enables cables to be sized in compliance with BS 7671 (the IEE Wiring Regulations...
Various techniques exist to enable the correct selection of batteries for UPS applications. The procedure described below is one of the more common. ...
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
myElectrical does not support or promote the use of copyrighted material without the copyright owner's consent. If you believe that material for which...
For the past few years I have reading eBooks on my HTC touch phone. On and off I have debated buying an eReader and recently purchased a Sony PRS-300 ...
Fault calculations are one of the most common types of calculation carried out during the design and analysis of electrical systems. These calculations...
The robot folding towels post below was interesting enough at the time to post a link. Recently I’ve come across a couple of other interesting videos...
Alternating current (a.c.) is the backbone of modern electrical power distribution. In this article I’ll be pulling some of the more important concepts...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.