Electrical and related buildings technology
When selecting a generator, there are inherent limits on the active and reactive power which can be delivered. Generators are normally sized for a certain...
A load flow study is the analysis of an electrical network carried out by an electrical engineer. The purpose is to understand how power flows around...
IEC 60947 is the circuit breaker standard and covers the marking of breakers in detail. Any manufacturer following this standard should comply with the...
This post is quick introduction and overview to different railway electrification voltages used in answer to a question sent in via email. While there...
A single phase system is perhaps the most common type of system most people are familiar with. This is what people have in their homes and what appliances...
myElectrical does not support or promote the use of copyrighted material without the copyright owner's consent. If you believe that material for which...
Installation of a UPS can help in reducing problems due to issues with the power supply. A lot of people relate this to nine key issues. Depending on...
I was digging in my bookshelf and came across the 80th Anniversary Association of Mine Resident Engineers, Papers and Discussions Commemorative Edition...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
The term 'N+1' relates to redundancy and simply means that if you required 'N' items of equipment for something to work, you would have one additional...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.